To make an order of an suit, please fill out this form completely.
Important Note: All fields are required.
Note: All figures are in cm.
To avoid errors, you can print out the document “Measurement Guide”. Write down all the necessary data and transfer them into the online form.
The document can be found here 
. You also can follow this instructions by follow this link.
Place the tape measure around the widest part of the chest – this is most direct in men below the armpits. To take measure exhale.
Tip: Make sure that the tape measure is resting directly on the nipples and the back straight.
Measure the circumference of your torso to the navel height.
Here again: standing comfortably, exhale.
Set for measuring the tape around the widest part of your buttocks.
Tip: Be sure to measure to wear a pair of pants that are not too much brushing (so best not jeans).
And previously empty pockets!
Place the tape measure from the shoulder seam close to the neck straight forward to the body. Keep your arm stretched on the body, and measure the length up to the thumb joint.
Tip: This dimension can be, if any take over, even by a well-fitting jacket.
Measure the width of your front jackets. For this purpose, place the tape measure horizontally at chest level – and in each case just below the armpit to the point where overlap arm and chest.
The rear width of the jacket is measured back to chest level – horizontally at applied arms below the shoulders by an arm-back crossover point to another.
Place the tape measure for this value close to the body to the shoulder over the shoulder.
Measure in your right (right-handed) or left (left-handed) upper arm at the widest point relaxed state.
Measure from shoulder to shoulder. Make sure that both ends are at an altitude. It is important to take this Mas exact because from here the sleeve length is taken.
Tip: A good landmark is the “outer edge” of the shoulder bone.
Place the tape measure at the point where, to which you have measured in Step. 9 Measure with an outstretched arm to the thumb approach for a standard length. Do you wish that the Jacket sleeves are shorter than the shirt sleeves, unplug two centimeters from the measured value.
Set for measuring the tape around the widest part of your buttocks.
Tip: Be sure to measure to wear a pair of pants that are not too much brushing (so best not jeans).
And previously empty pockets!
To determine this value optimally, it is recommended to measure to attract a well-fitting pants. Measure the circumference of the fuselage directly above the waistband, hold the tape measure closely to the body.
Run the tape measure from the front waistband end straight through between the legs to the rear Bund end.
Tip: For this value, it is important to keep the band close to the body.
Place the tape measure around the widest part of the thigh. Hold the tape to measure so loose that even one finger between the leg and band fits.
Measure the circumference at the widest part of the knee.
To determine the width of the leg bands, place the tape measure around the heel to the point on the instep where the pant leg to rest.
